NUK Smart Control Multi 310 Mode D'emploi page 33

2. To stop a video recording, tap
the RECORD button again.
7.1.4 Replaying video
Tap the PLAY BACK button to
play back a video recording. The
available videos will be shown in
a list. Select the desired video
from the list.
7.1.5 Switching off picture or sound
Tap the VIDEO button to switch
the image from the baby monitor
on and off. All the other functions
remain active.
Tap the AUDIO button to switch
the sound from the baby monitor
on and off. All the other functions
remain active.
7.1.6 Adjusting volume
Tap the Audio Volume button to
adjust the volume of the baby
monitor.
• A menu appears in which you can adjust
volume by means of a slide controller.
• Confirm the entry with OK.
Note: the microphone sensitivity set on your
smartphone will likewise have an impact on
the volume of the baby monitor (see
"7.1.7 Adjusting microphone sensitivity" on
page 31).
7.1.7 Adjusting microphone
sensitivity
Tap the Mic. Volume button to
adjust the sensitivity of the baby
monitor microphone.
Note: this setting also affects the resolution
of a message. If you reduce sensitivity here,
you need to increase noise detection (see
"7.2.4 Adjusting
message" on page 33) in order to receive a
message in the event of the same noise
level in the nursery.
• A menu appears in which you can adjust
sensitivity
controller.
• Confirm the entry with OK.
7.1.8 Playing music via the baby
monitor
1. Tap the SEND MUSIC button
to play
loudspeaker
monitor.
– A list of the tracks stored on your
smartphone appears. Select one of
these tracks.
– If you have a large number of tracks
stored, it may take some time for the
app to scan the relevant list, so wait
until the list appears.
– This function is only possible with an
internal WLAN (Wi-Fi) connection. The
data rate is not adequate with an
internet connection, so the icon does
not appear in the menu.
31
the resolution
by means of
music via the
of the baby
of a
the slide