Cleaning And Maintaining The Device - NUK Smart Control Multi 310 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7. Use the slide controllers to select the
volume of the noises and "Trigger
Duration".
8. Confirm your entries with OK.
7.2.5 Adjusting the night light
This menu item is not available via the
internet.
In this menu item, you can select from a
variety of settings.
1. Switch on the night light by setting the
"Night light" switch to ON.
As soon as the night light is switched on,
the colours available are displayed.
2. Select the desired colour using the slide
controller.
3. Set "Breathing light" to ON if you want to
have a flashing blue light.
The switch for "Night light" automatically
goes to OFF.

8. Cleaning and maintaining the device

Warning! To avoid the risk of
electric shock, injury or damage:
– Always disconnect the camera
network cable from the power
socket
device.
– Never immerse the individual
parts in water.
Caution! Under no circumstances use
abrasive, corrosive or scratching cleaning
agents, as these could damage the device.
before
cleaning
4. Under "Timer", select a time between 5
and 30 minutes after which the night light
will automatically switch off again.
7.2.6 MP3 upload
This menu item is not available via the
internet.
Use this menu item to load an MP3 file
(max. 5 MB) onto the baby monitor.
Use the music button 10 then to play
the track.
There does not need to be any
connection between the baby monitor and
the smartphone while this track is playing.
This track is only saved temporarily. As soon
as the power supply to the baby monitor is
interrupted, the track will be lost and the
default song will be played.
7.2.7 Resetting the baby monitor to
default settings
In this menu, you can reset all settings to
factory settings. The SSID name and the
password are reset to factory settings.
It may be that the camera then has to be re-
registered.
This menu item is not available if the
smartphone and the baby monitor are
connected via the internet.
• To
reset
button 16
10 seconds.
1. If necessary, wipe the individual parts
with a suitable cleaning cloth.
Note: you can moisten the cleaning cloth
slightly (mist it) if the parts are very dirty,
the
but no liquid may get into the device.
1. Only use the baby phone again when all
the parts have fully dried out.
2. Carefully clean the camera lens when
necessary with a soft cloth, e.g. tissue for
cleaning spectacles.
34
the
camera,
keep
depressed
for
Reset
at
least

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

10.256.406

Table des Matières