Renfert Twister Mode D'emploi page 25

1.3 Benchtop Models
The stand (Fig. 8) can be used to convert
the vacuum mixer to a floor-mounted ap-
pliance.
1. Position the stand on a level surface.
2. Hang the appliance in the stand
(Fig. 9).
3. Secure the appliance by tightening the
knurled nut (Fig. 7).
Tighten the knurled nut securely.
The stand is not part of the standard de-
livery and must be ordered as an optional
accessory (refer to section „7. Accesso-
ries" ).
1.4 Electrical connection
Ensure the mains supply and
voltage marked on the name-
plate is identical.
• Secure the mains cable through the
cable safety catch (Fig. 10).
• Plug mains cable into socket on appli-
ance (Fig. 11).
• Plug in at the mains (Fig. 12).
1.5 Compressed air supply
Twister venturi only
1. Attach the compressed air tube into
the tube connector of the input filter as
far as it will go (Fig. 13). There will be
a slight resistance to overcome when
attaching.
2. Select the proper coupling from the
set provided and install it on the other
hose end to connect it to the com-
pressed air system (Fig. 14).
3. Connect to compressed air line system
(Fig. 15).
The best vacuum performance is
attained at the operating pressure
specified in the technical data (see
section G.2). Use filter pressure
regulator if necessary (see section
„7. Accessories").
The vacuum mixer is now ready for
operation.
2. Operation
2.1 Gerätebeschreibung
(Fig. 16) / (Fig. 17)
A Control knob (set mixing parameters,
start, stop, aerate)
B Parameter keys
C Display
D Appliance switch
E Fuse
F Appliance socket
G Suction filter system
Twister venturi only
H Silencer
I Inlet filter
K Compressed air connection
2.2 Key Symbols
Mixing pa- Symbol
rameters
Mixing time
Speed
Vacuum
*) Twister, no. 1826: in 5% increments
**) Twister venturi, no. 1827: Choice of 80% and 100% vacuum
levels only.
2.3 Display
The following will appear on the display
(Fig. 18):
A Large-scale display of parameter
(here: mixing time) / (here: remaining
mixing time)
B Parameter symbols.
The symbol „vacuum" only shows
when less than 100% vacuum has
been set.
C Selected speed
D Selected vacuum level
E Current vacuum level (bar graph)
- 3 -
Adjustment Factory
range setting
0:00 - 9:55 1:00
min:sek
100 - 450 350
1/min
70 - 100 *) 100
80 / 100 **)
%
EN