auna Oxford Mode D'emploi page 45

TROUBLESHOOTING
No power
• Check the power plug connection at the wall socket.
• Short press the Power button to power on the Retro Turntable.
The tone arm skips grooves, slides over the record or does not move
• The Retro Turntable is not on a flat surface. Please move the product to
a flat and stable surface
• The record is dirty or scratched. Clean the record with a record cleaner
or play a different record.
The Turntable speed is incorrect
Select the correct speed according to the specification on the record. (33, 45
or 78 RPM).
Unable to pair with a BT device
• Check that you are in BT mode.
• Ensure that you are within range of the Retro Turntable for BT
functionality, 10 metres or less (33 feet or less).
• Move any other unnecessary BT devices/electrical equipment away
from the Retro Turntable and if possible, turn them off or disable their
BT functionality.
No sound / Sound distortion
• Adjust the volume
• The stylus is dirty. Clean the stylus with a soft brush.
• The record is dirty or dusty. Clean the record with a record cleaner.
• If you are using BT, adjust the volume on the secondary connected
device and on your Retro Turntable
• Check that you are in the correct mode for the music that you wish to
listen to.
Retro Turntable powers off:
Your Retro Turntable has been designed to automatically go to Standby
mode after approximately 20 minutes without an audio signal, to save
power. Short press the Power button to turn the product back on again.
EN
45