auna Oxford Mode D'emploi page 33

FIRST STEPS AND USE
Set the clock
In standby mode:
1. Short press the Repeat button.
2. A '0000' will now flash in the display. Short press the Tune/Skip buttons
to display the correct hour and then short press the Play button to
confirm.
3. The minute digits will then flash in the display. Short press the Tune/
Skip buttons to display the correct minutes and then short press the Play
button to confirm.
4. Your clock is now set and will be displayed in Standby mode.
Power on
Short press the Power button. Your Retro Turntable will turn on, 'PH' will be
displayed. and your product will be in Phono/Turntable modes.
Standby mode
This product is designed to go to Standby mode automatically after 20
minutes (approximately), if it does not receive an audio signal. Short press
the Power button to switch your product back on again.
Changing the source (mode)
Short press the source button to change between Phono (Turntable), CD,
DAB, FM Radio, BT and Aux in modes. Please check the display, which will
confirm the mode.
Adjusting the volume
Turn the large right hand rotary volume control clockwise to increase the
volume and anti-clockwise to decrease the volume.
Using headphones
You can connect headphones with a 3.5mm plug (not included) to the socket
on the front of the Retro Turntable. When you have headphones connected
the speakers are switched off and all sound is via the headphones.
Note: Always keep the volume within reasonable limits.
EN
33