auna Oxford Mode D'emploi page 39

Tuning to an FM station
In FM mode:
1. Repeatedly short press the Repeat button to move through the preset
locations (1-30).
2. When you pause between each press, the frequency stored under each
preset location will be displayed and your product will tune to and play
the stored station.
DAB RADIO MODE
• Check that your Retro Turntable is in DAB mode. If you are not already
in DAB mode, repeatedly short press the Source button to go to DAB
mode (check the display)
• The first time you use your Retro Turntable or if the station list is empty,
your Retro Turntable will automatically begin to scan for DAB radio
stations. Scan and then after a short delay the number of stations found
during the scan will also be displayed.
• If you were listening to a DAB station when you switched the Retro
Turntable off, then this station will automatically be selected when you
switch the radio back on.
Wire radio aerial
Please make sure that the wire aerial on the back of the Retro Turntable
is fully extended and adjusted before you attempt to tune to a DAB radio
station (a vertical position is recommended). This will ensure that the
maximum signal strength is available when the Retro Turntable begins to
scan. Extending the aerial also ensures the best possible sound quality.
Changing DAB stations
In DAB mode:
1. Use the - Tune/Skip + buttons to scroll through the available stations.
2. When the station that you would like to listen to is displayed, short press
the Play button. There will be a short delay whilst your Retro Turntable
tunes to your selected station.
Scanning for DAB stations
With DAB radio, additional stations and services regularly become available
so it's a good idea to carry out a manual scan every now and then to make
sure that you have the most up to date station listing stored within the
memory of your Retro Turntable.
If you have moved your Retro Turntable to another location, e.g.: if you go
EN
39