RIB UP Instructions page 47

Available
4- 5+
6- 7+ 24Vdc power supply for accessories
8- 9+ ACG9631 Emergency batteries back-up connection
10- COM Common inputs (negative).
Opening limit switch (connected in factory)
11 - FCA
12 - FOTO RAL Input Exclusion for Safety 14
N.C. safety, the opening of the contact (16-18) stops the movement of the door and inhibits any command. The
resetting of the contact and a subsequent "open" command makes the door open completely in slow motion;
13 - STOP
then it will wait for an OPEN command.
The automation will resume the automatic operation with the previous parameters.
N.C. Input terminal for a pair of safety photocells; the interruption of the open door range keeps the automatic
14 - FOTO
closure time paused until such range is resumed, whereas in the closure phase, it reverses the movement.
15 - R. EXT Outward opening sensor; it sends an "open" command. In "closure" phase, it reverses the movement.
16 - R. INT Inward opening sensor; it sends an "open" command. In "closure" phase, it reverses the movement.
N.O. input, if closed with input COM (22-16), it "opens" the automation keeping it in position until the contact
itself is reopened.
Set parameter "I" to 0 on the LCD PROGRAMMER (optional) in order to manage the open-close orders
17 - OPEN
alternately; Automatic closure is not active.
Set parameter "I" from 1 to 9 according to the desired automatic closure time ( I1=1 s , I2=2 s ,
neg.
etc...).
Interlock feature (anti-tailgating); connecting terminal 18 (INT.I) of a control panel to terminal 19 (INT.O) of
18 - INT. I
another one and vice versa. The automation that first get an "open" command will lock the second automation
19 - INT. O
(closed door) until the first one is completely closed.
N.O. soft touch command for mobility-impaired.
30 - OPEN-HCP
This command opens the door increasing to 30s the pause time before automatic closure.
31- COM Common inputs (negative).
47
G
B