Nemaxx PW18 Manuel D'utilisation page 5

1.2 OPERATING INSTRUCTIONS
● Turn off the heater in case of failure or malfunction.
● NEVER manually load the pellet into the burner.
● The accumulation of unburned pellets in the burner after repeated "misfire" must be removed before
proceeding with a new ignition.
● Do not wash the inside of the stove with water.
● Do not wash the stove with water. Water may enter the unit and damage the electrical insulation, causing
electric shock.
● Do not expose your body to hot air for a long time. Do not overheat the room where you are staying and
where the stove is installed. This can damage the physical condition and cause health problems.
● Do not expose to direct the flow of hot air plants or animals. It could have harmful effects on plants or
animals.
● Do not use other fuel other than DIN PLUS Certified - ÖNORM wood pellets.
● Install the stove in a suitable location which has available all necessary facilities required such as fire pre-
vention facilities and all necessary utilities are available such as - but not limited - power supplies (air and
electric) and exhaust fume, in conformity with the provisions in force.
● The storage of the stove and the ceramic coating must be stored in a dry and humidity free premises.
● It is recommended to place the stove directly on the floor, and whereas this floor is made of flammable
materials, in this case it is required to isolate properly.
● Never turn on any heater with flammable materials in the event of failure of the ignition system.
INFORMATION
● In case of any problems, get in touch with your dealer, or a qualified authorised engineer, and if a repair is
necessary, insist on the use of original spare parts.
● Use only the fuel recommended by manufacturer (for Italy pellets with a diameter of 6 mm and for other
European countries with a diameter of 6-8 mm) and provided only with an automatic supply system.
● Periodically check and clean the smoke outlet ducts (connection to the flue pipe).
● Accumulated unburnt pellets in the burner after repeated failed ignitions must be removed before
1.3 IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH
EC DIRECTIVE 2002/96/EC
At the end of its working life, the product must not be disposed of as urban waste.
It must be taken to a special local authority differentiated waste collection center or to a dealer providing this
service.
Disposing of a appliance separately avoids possible negative consequences for the environment and health
deriving from inappropriate disposal and enables the constituent materials to be recovered to obtain significant
savings in energy and resources.
As a reminder of the need to dispose of appliances separately, the product is marked with a crossed-out
wheeled dustbin.
[ EN ● 5 ]
Version: 2.0
KEN002PW18 25.11.2019