Nemaxx PW18 Manuel D'utilisation page 21

Switching ON / switching OFF
Switching ON / switching OFF
The heater switching ON and switching OFF ist
performed through ON / OFF key
After switching on, the message, "CLEANING"
will be shown on first, in order to clean the fire
pot.
In the same way, push
switching off Period, the message shows:
After the temperature in the stove is cold
enough, finally, the phrase 'GOODBYE' is
displayed.
, then at the
[ EN ● 21 ]
The switching on Stage, which has the duration
of about 5-15 minutes, are necessary to the
resistance to carry the pellets at the switching
on temperature, (depends from the heater).
The switching on procedure is showed from a
passage set showed in the display as previous
one and then:
Thirdly, after second phase is showed from
the message 'FEEDING'. In this phase are
performed the chimney verification operations
and the pellets will be loaded in the melting pot.
The successive phase will be showed from the
inscription 'Lighting'. This state remains up to
when the smokes temperature doesn't exceed
the planned threshold
When the Lighting phase is finished, some
minutes will spend necessary for the flame
stabilization. This phase is showed from the
message 'STABILIZATION' which finishes after
some minutes going up at the work phase
Version: 2.0
KEN002PW18 25.11.2019