Nemaxx PW18 Manuel D'utilisation page 29

IMPORTANT!
It means fire put out automatically during the operation,
when the exhaust gas temperature is below 40-45 degree.
Such as:
1. There has no fuel at hopper.
2. Auger motor is broken and stop feeding the fuel.
It means there is earthquake during the operation time or
you tilt the stove. Only for the Japan version
It means that there are some problems with vacuum
Switch.
Such as door has not been closed properly; Combustion
fan's speed cannot Speed up; There is some leakage about
the stove or exhaust pipe is blocked and so on.
During the operation, the stove is interrupted by electronic
cut.
Check everything is fine, you can press to delete the Error code
It means Igniter failure at the beginning.
Such as:
1. There have clinkers in fire pot.
2. The fire pot has not put right.
3. The switch which is located beside the combustion fan
to test the exhaust gas temperature sensor, is broken.
4. The igniter is broken.
Problem for the temperature sensor.
Unplug or broken or water temperature is too high
It means that the high temperature sensor - which is loca-
ted below the hopper, has some problem, such as:
1. The switch is broken.
2. The temperature is too high that the stove runs not
properly
It means you need to clean the stoves.
[ EN ● 29 ]
Version: 2.0
KEN002PW18 25.11.2019