Kärcher MC 130 Mode D'emploi page 82

1 Side brush arm
2 Stopper
Carefully move in the side brush arm all the way up to

the stop.
Move in the side brush arm of the other side.

Check if both side brush arms are positioned correctly.

Drain off the suction opening.

Ignition in position 1 in working mode (do not start the

motor), the brushes move down and the hydraulic sys-
tem is depressurised.
Disconnect electric, hydraulic and water connections.

Remove the suction hose between the waste container

and the suction mouth.
Disconnect the water hose (thick).

Move out the sweeping system using a pallet truck.

1 Storage box
2 Lines and hoses
Place lines and hoses in the storage boxes.

Put the sweeping system down in a protected place

and move out the pallet truck.
82
8.3.3 Attach the sweeping system
Figure: attached and connected sweeping system on the
MC 130
1 Signal connector for attachment recognition
2 Connections for left side brush (hydraulic and water)
3 Lock sweeping system
4 Connections for right side brush (hydraulic and water)
Attach the sweeping system to the vehicle in the re-

verse order.
Lock the sweeping system (bottom lever position).

Important note
See chapter "Checking/adjusting attachment lock".
Connect the hydraulic hoses with the relevant cou-

plings.
Note
Prior to attaching the hydraulic hoses, depressurise the
hydraulic system.
30
-
EN