Bosch VitaPower 4 Serie Manuel D'utilisation page 42

en Troubleshooting
Fault
Appliance switches off
during use.
The programme does
not start.
The To-Go blade in-
sert cannot be con-
nected to the main
unit.
To-Go blender jug is
leaking.
Liquid is leaking from
the blade insert.
42
Cause and troubleshooting
Processing quantity is too great or processing time
was too long.
Set the rotary switch to ⁠ .
▶
Reduce the processing quantity.
▶
Allow the appliance to cool down to room temperat-
▶
ure.
The rotary switch is not set to .
Set the rotary switch to ⁠ .
▶
The programme has been cancelled using the pro-
gramme button.
Set the rotary switch to ⁠ .
1.
Press the programme button for the required pro-
2.
gramme.
Outlet protection is active.
Screw the To-Go blade insert and the To-Go
▶
blender jug in by turning them in a clockwise direc-
tion.
a The To-Go blender jug and To-Go blade insert are
fully and tightly screwed in.
a The and
Seal is missing from the lid.
Insert the seal.
▶
Seal between the blender jug and the blade insert is
missing.
Insert the seal on the EasyClick blade insert.
▶
a The seal is seated in the groove.
a The sealing lips point in the direction of the blender
jug.
a The smooth sealing surface lies against the EasyC-
lick blade insert.
markings match up.