Manitowoc NEo UD0140A Manuel D'installation, D'utilisation Et D'entretien page 18

Maintenance
Step 5 Mix a solution of cleaner and warm water.
Depending on the amount of mineral buildup, a larger
quantity of solution may be required. Use the ratio in the
table below to mix enough solution to thoroughly clean
all parts.
Solution Type Water
Cleaner 1 gal. (4 l)
Use half of the cleaner/water solution to clean all
components. The cleaner solution will foam when it
contacts lime scale and mineral deposits; once the
foaming stops use a soft bristle brush, sponge or cloth
(not a wire brush) to carefully clean the parts. Soak the
parts for 5 minutes (15 – 20 minutes for heavily scaled
parts). Rinse all components with clean water.
Step 6 While components are soaking, use half of the
cleaner/water solution to clean all foodzone surfaces of
the ice machine and bin. Use a nylon brush or cloth to
thoroughly clean the following ice machine areas:
• Evaporator plastic parts – including top, bottom and
sides
• Bin bottom, sides and top
Rinse all areas thoroughly with clean water.
Step 7 Mix a solution of sanitizer and warm water.
Solution Type Water
Sanitizer 3 gal. (12 l)
Use half of the sanitizer/water solution to sanitize all
removed components. Use a spray bottle to liberally
apply the solution to all surfaces of the removed parts or
soak the removed parts in the sanitizer/water solution.
Do not rinse parts after sanitizing.
16
Mixed with
16 oz (500 ml) cleaner
Mixed With
2 oz (60 ml) sanitizer
Step 8 Use half of the sanitizer/water solution to
sanitize all foodzone surfaces of the ice machine and
bin. Use a spray bottle to liberally apply the solution.
When sanitizing, pay particular attention to the following
areas:
• Evaporator plastic parts - including top, bottom and
sides
• Bin bottom, sides and top
Do not rinse the sanitized areas.
Step 9 Replace all removed components, wait 10
minutes, then reapply power and water to the ice
machine
Step 10 Press the Clean button. Water will flow through
the water dump valve and down the drain. Wait until the
water trough refills, then add the proper amount of ice
machine sanitizer to the water trough.
Model
U0140
U0190
U0240
U0310
Wait until the sanitize cycle is complete (approximately
22 minutes) then press the Ice button to start ice making.
Section 4
Amount of Sanitizer
1 ounces (30 ml)
2 ounces (60 ml)
2 ounces (60 ml)
2 ounces (60 ml)
Part Number 040002909 5/13