Manitowoc NEo UD0140A Manuel D'installation, D'utilisation Et D'entretien page 15

Touch Pad Features
The touch pad offers a series of pressure sensitive
buttons to control ice machine operation and provide
operational status.
On/Off - Blue = Machine On
Off = Machine Is Off
Delay - Blue = Delay Mode On
Off = Delay Mode Is Off
Clean - Yellow = Clean Cycle On
Off = Cleaning is Off
Bin Full - Blue = Bin Is Full
Off = Bin Is Not Full
Service - Red = Needs Service
Off = Doesn't Need Service
ON/OFF
The On/Off Button is used to start and stop ice making.
The blue light indicates whether the ice machine is in Ice
Making (light on) or Off (light off).
Part Number 040002909 5/13
Section 3
Operation
DELAY
Pressing the Delay button will start a delay period. The
ice machine will finish the freeze and harvest cycle and
then start the delay period.
• Pressing the button once will start a 4 hour delay
period.
• Pressing the button twice will start a 12 hour delay
period.
• Pressing the button three times will start a 24 hour
delay period.
• Pressing the button four times will cancel the delay
periods.
NOTE: The delay period will be cancelled if power is
interrupted to the ice machine. When power is restored,
the ice machine will start an ice making cycle.
CLEAN
Pressing the Clean button for 3 seconds will start a clean
cycle. After the clean cycle is complete, the ice machine
will automatically start an ice making cycle.
• Pressing the Clean button again within 30 seconds of
the clean cycle starting will abort the clean cycle.
• Pressing the Clean button after 45 seconds into the
Clean cycle will de-energize the On/Off LED and the
ice machine will stop after the Clean cycle is
complete.
Pressing the On/Off button will pause the Clean cycle.
The On/Off light will flash on/off to indicate pause mode.
Pressing the On/Off button again will continue the Clean
cycle from the point of interruption.
BIN FULL
The Bin Full light energizes when the bin is full or is de-
energized if the bin is not full.
SERVICE
The service light indicates the machine needs attention.
• Refer to Section 5 for more information if this light is
energized.
13