Remote Control - GE AEE24 Mode D'emploi

Using the Air Conditioner
Heat Mode
Heat mode at Low, Med, High or Auto Fan Speed
Temperature Increase
pads to set the desired temperature between 61°F and
86°F in 1°F increments.
Cool Mode
Cool mode at Low, Med, High or Auto Fan Speed
Temperature Increase
pads to set the desired temperature between 61°F and
86°F in 1°F increments.
An electronic thermostat is used to maintain the room
temperature. The compressor will cycle on
and off to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air will become
cooler. Set the thermostat at a higher number and the indoor
air will become warmer.
NOTE: If the air conditioner is off and is then turned on
while set to a Cool setting or if turned from a fan setting to
Energy Saver Mode
Controls the fan.
ON—The fan will cycle on and off with the compressor.
This results in wider variations of room temperature and
humidity. Normally used when the room is unoccupied.
NOTE: The fan may continue to run for a short time after
the compressor cycles off.
Fan Only Mode
provide air circulation and filtering without cooling. Since
fan-only settings do not provide cooling, a Set temperature
cannot be entered. The room temperature will appear
in the display.
Auto Fan Speed
Set to Auto fan speed for the fan speed to automatically set
to the speed needed to provide optimum comfort settings
with the set temperature.
If the room needs more cooling, the fan speed

Remote Control

To ensure proper operation, aim the remote control at
the signal receiver on the air conditioner.
Make sure nothing is between the air conditioner and
the remote control that could block the signal.
Power Outage Recovery Feature
In the case of a power outage or interruption, the unit will
automatically re-start in the settings last used after the
power is restored. If the Delay 1–24hr feature was set, it
49-5000552 Rev. 0
An electronic thermostat is used to maintain the room
temperature. The heater will cycle on and off to keep the
room at the set level of comfort.
Decrease
a Cool
Decrease compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling—Select the Cool mode and
High or Med fan with a middle set temperature.
For Maximum Cooling—Select the Cool mode
and High fan with a lower set temperature.
For Quieter and Nighttime Cooling—Select the
Cool mode and Low fan with a middle set temperature.
OFF—The fan runs all the time, while the compressor
cycles on and off.
NOTE: Auto Fan Speed cannot be used when in the
Fan Only Mode.
will automatically increase. If the room needs less cooling,
the fan speed will automatically decrease.
NOTE: Auto Fan Speed cannot be used when in the
Fan Only Mode.
The remote control signal has a range of
up to 20 feet.
Make sure batteries are fresh and installed correctly as
indicated on the remote control.
Remote contains a magnet allowing it to attach to metal
surfaces.
will resume countdown. You may need to set a new time if
desired.
5