Controls - GE AEE24 Mode D'emploi

Controls

Features and appearance will vary.
Lights beside the touch pads on the air conditioner control panel indicate the selected settings.
NOTE: The display always shows
setting the Set temperature or the
Delay timer.
Air Conditioner Controls
1. Power Pad
Turns air conditioner on and off. When turned on, the
display will show the room temperature.
2. Display
Displays the set temperature while in Heat, Cool or
Energy Saver mode. Displays the room temperature
while in Fan mode. Show time remaining in hours
when in Delay mode.
Saver mode. The Set light will turn on while setting.
Delay Timer Increase
4.
Each touch of the Increase
the unit or the Increase
remote control will set the delay time when using the
Delay 1–24hr timer. The Set light will turn on while
setting.
5. Fan Speed Pad
on the unit. NOTE: On the remote control, use the fan
+
speed Increase
speeds to Low, Med or High
Auto fan on.
6. Mode Pad
Delay ON—When the air conditioner is off, it can be
s
Saver or Fan Only mode.
Note: The default temperature reading on the display is degree Fahrenheit ( °F). To change the display to degree
Celcius (°C), press the Temp Increase
process to change back to degree Fahrenheit (°F)
4
Light indicates the unit
is in the temperature or
delay time Set mode.
Heat
Light indicates the
delay timer is set.
Heat, Cool or Energy
(–) Pads
Decrease pads on
+ –
Decrease pads on the
Low, Med, High or Auto
–
pads to set the fan
Auto pad to turn
Heat, Cool, Energy
and Temp Decrease
7. Delay Pad
Delay ON—When the air conditioner is off, it can be set
to automatically come on in 1 to 24 hours at its previous
mode and fan settings.
Delay OFF—When the air conditioner is on,
it can be set to automatically turn off in 1 to
24 hours.
How to set:
Press the Delay 1–24hr pad on the unit or on the
remote control. Each touch of the Increase
Decrease pads on the unit or the Increase
–
Decrease pads on the remote control will set the timer
in 1-hour intervals. The Set light will turn on while setting.
To review the remaining time on the Delay 1–24hr timer,
press the Delay 1–24hr pad on the unit or on the remote
Increase
+
unit or the Increase
control to set a new time if desired.
To cancel the timer, press the Delay 1–24hr pad until
the light on the Delay 1–24hr pad goes off.
buttons together and hold for 3 seconds. Repeat the
Fan Fan
Remote Control
+
Decrease pads on the
–
Decrease pads on the remote
49-5000552 Rev. 0