Window - GE AEE24 Mode D'emploi

Installation Instructions
1. WINDOW REQUIREMENTS
• These instructions are for a standard double-hung
window. You will need to modify them for other
types of windows.
• The air conditioner can be installed without the
side curtain panels if needed to fit in a narrow
window. See the window opening dimensions.
• All supporting parts must be secured to firm wood,
masonry or metal.
• The electrical outlet must be within reach of the
power cord.
• Follow the dimensions in the illustration for your
model.
(With accordion panels)
2. STORM WINDOW
REQUIREMENTS
A storm window frame will not allow the air
conditioner to tilt toward the outside, and will keep
it from draining properly. To adjust for this, attach a
piece of wood to the sill.
WOOD PIECES
WIDTH: 2
LENGTH: Long enough to fit inside the window
frame.
THICKNESS: To determine the thickness, place
than the top of the storm window frame or the vinyl
frame.
Attach securely with nails or screws provided by the
installer.
higher
than storm

window

frame
Storm window
frame
49-5000552 Rev. 0
higher
than vinyl frame
(on some windows)
Wood
Sill
Vinyl frame
3. PREPARE THE AIR
CONDITIONER
A. Pull the top of the front panel out and down.
Remove the filter. Remove the front panel by
lifting up at an angle.
Remove the four front screws. Save them for
B.
reinstalling the front housing
C. Grasp the lower corners of the grille while
pressing in on the case sides with your finger
tips. Pull out to release and lift it up.
NOTE: Do not pull the bottom edge toward you
more than 3 or you may damage the tabs of the
grille.
D. When the front grille is removed the control panel
will still be attached by a harness. Turn the grille
around so you can see the back side of the grille.
Remove the 2 screws to separate the control
panel housing from the grille.
NOTE: Be sure to save these screws. You will
need them later in the installation.
Remove Screws
.
9