Window Requirements - GE AEN10 Série Manuel D'utilisation Et Instructions D'installation

WINDOW REQUIREMENTS

1
• These instructions are for a standard
double-hung window. You will need to modify
them for other types of windows.
CAUTION:
bolts do not contact the window sill, or
if you have a window without a sill, you
must order accessory kit RAK87 to
properly install this air conditioner.
Call 800.626.2002 or visit GEAppliances.com.
• The air conditioner can be installed without
the accordion panels if needed to fit in a
narrow window. See the window opening
dimensions.
• All supporting parts must be secured
to firm wood, masonry or metal.
• The electrical outlet must be within reach of
the power cord.
(With accordion panels)
STORM WINDOW REQUIREMENTS
2
A storm window frame will not allow the air
conditioner to tilt toward the outside, and will keep
it from draining properly. To adjust for this, attach
a piece of wood to the sill.
WOOD PIECES –
WIDTH: 2"
LENGTH: Long enough to fit inside the window
frame.
THICKNESS: To determine the thickness, place a
piece of wood on the sill to make it 1/2" higher
than the top of the storm window frame or the
vinyl frame.
Attach securely with nails or screws provided
by the installer.
1/2" higher
than storm
window
frame
Storm window
frame
Installation Instructions
If the sill support
16.4" min.
25.25" to 38"
1/2" higher
than vinyl frame
(on some windows)
Wood
Sill
Vinyl frame
REMOVE THE AIR CONDITIONER
3
FROM THE CASE
A Remove and save the 2 screws from the lower
sides of the front grille.
Grasp the lower corners of the grille while
B
pressing in on the case sides with your finger
tips. Pull out to release and lift it up.
NOTE: Do not pull the bottom edge toward you
more than 3" or you may damage the tabs of
the grille.
Remove the ground screw from each side of
C
the case. Keep them in a safe location.
NOTE: Be sure to save these screws. You will
need them later in the installation.
2
Slide the air conditioner from the case by
D
gripping the base pan handle and pulling
forward while bracing the case. Do not pull or
lift on the styrofoam discharge area.
9
FRONT
FRONT
FRONT
Do not
pull or
lift in this
area—
damage
to the
unit may
result
FRONT