Important - GE AEN10 Série Manuel D'utilisation Et Instructions D'installation

INSTALL SUPPORT BRACKET AND
9
FOAM TOP WINDOW GASKET
A
CAUTION:
To prevent broken glass or
damage to windows, on
vinyl or other similarly
constructed windows,
attach the support bracket
to the window side jam.
Attach the support bracket
with one Type C screw.
Cut the foam top window gasket to the window
B
width.
Stuff the foam
C
between the glass
and the window
to prevent air and
insects from getting
into the room.
NOTE: If the gasket supplied does not fit your
window, obtain appropriate material locally to
provide a proper installation seal.
INSTALL THE AIR CONDITIONER
10
IN THE CASE
Slide the air conditioner into the case by
A
the base pan. Do not push on the controls,
styrofoam air discharge housing or the finned
coils. Make sure the air conditioner is firmly
seated.
Base Pan
Installation Instructions
Vinyl
Wood
Do not press on
these areas—
damage to the unit
may result
12
INSTALL THE AIR CONDITIONER
10
IN THE CASE (CONT.)
B Replace the 2 ground screws removed earlier,
one on each side of the case.
IMPORTANT: The ground screws must be
reinstalled to ensure a proper ground.
Attach the front grille to the case by inserting
C
the tabs on the grille into the slots on the front
top of the case. Push the grille in.
Secure the front grille to the case by replacing
D
the 2 screws removed earlier. Press on the top
of the grille to help
with side screw installation.
E Connect power.