Remote Control Features - GE AE1CD10AM Manuel D'utilisation Et Instructions D'installation

About the remote control.
The remote control transmits the signals to the system.
Features and appearance may vary.
AUTO—In this mode, the unit automatically
controls the room temperature within the
range of 77ºF and 68ºF. The fan will run
continuously while the unit is in AUTO mode.
When the room temperature exceeds 77ºF, the
unit will go into COOL Mode. When the room
temperature drops to 73ºF, the fan will
continue to run but COOL Mode will turn off.
When the temperature drops below 68ºF, the
unit will go into HEAT Mode. When the
temperature reaches 73ºF, the fan will
continue to run but HEAT Mode turns off.
NOTE: This temperature range setting cannot
be adjusted and will not be displayed.
COOL—Use to cool the room to the desired
temperature set between 61ºF and 86ºF.
NOTE: The unit will not provide optimum
cooling if the outside temperature is below
60ºF. Under certain conditions, the unit may
activate the antifreeze protection cycle for
approximately 5 minutes to remove ice from
the indoor coil.
DRY—Use to dehumidify the room. The fan will
run at a fixed low speed to provide maximum
dehumidification. The temperature can be set
between 61ºF and 86ºF.
FAN—Use to turn ON and OFF the fan-only
operation. COOL, HEAT or DRY mode will not
be provided.
HEAT (on models so equipped)—Use to warm
the room to the desired temperature set
between 61ºF and 86ºF.
NOTE: The unit will not provide optimum
heating if the outside temperature is below
14ºF. Under certain conditions, the unit may
activate the antifreeze protection cycle for
approximately 8 minutes to remove ice from
the outdoor coil. During this cycle, it is normal
to hear operating sounds such as refrigerant
flowing inside the system.
4
Fan setting
Mode
Temperature
Timer set
ON and OFF
Operation
Sleep on
Swing on
Clock and timer