Troubleshooting Tips; Possible Causes; Normal Operating Sounds - GE AE1CD10AM Manuel D'utilisation Et Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Before you call for service...
Troubleshooting Tips: Save time and money! Review the chart below first and you may not need to call for service.
Problem
The system
does not start
The system does not
cool as it should
The remote control
display is faint or
shows no display
at all

Normal Operating Sounds

I
These sounds are common during the
antifreeze cooling or heating modes.
I
You may hear a sound like water flowing. This
is the sound of refrigerant flowing inside the
system.

Possible Causes

The fuse is blown/circuit
breaker is tripped.
The Timer operation is not set
correctly.
The unit does not operate when • This is normal. Wait about 3 minutes and the unit
restarted.
Airflow is restricted.
The temperature control may
not be set high or low enough.
The air filter is dirty.
The room may have been hot.
Cold air is escaping.
The batteries are inserted
incorrectly.
The batteries may be dead.
What To Do
• Check the house fuse/circuit breaker box and
replace the fuse or reset the breaker.
• Check the Timer functions and make sure they are
set to the desired settings.
will restart.
• Make sure there are no curtains, blinds or furniture
blocking the front of the system.
• Turn to a lower or higher setting. The lowest setting
provides maximum cooling.
• Clean the filter at least every 30 days.
See the Operating Instructions section.
• When the system is first turned on, you need
to allow time for the room to cool down.
• Check for open furnace floor registers and cold air
returns.
• Check the position of the batteries. They should be
inserted in the opposite (+) and (–) direction.
• Replace the batteries.
I
A noise that sounds like air being released is a
design feature of dehumidifying water being
processed inside the system.
I
You may hear a clicking noise when you start
or stop the unit. This sound is the expansion
or contraction of the unit due to changes in
the temperature.
GEAppliances.com
17

Publicité

Table des Matières
loading

Table des Matières