Remote Control - GE AKCQ08A Manuel Du Propriétaire Et Instructions D'installation

Using the Air Conditioner - Controls
Appearance may vary.
1. POWER
Turns air conditioner on and off.
2. Display
Displays the temperature setting. Displays hours when
setting the timer.
3. Mode
Use to set COOL, HEAT (on some models), DRY, AUTO,
or FAN modes. Indicator lights on the controls will show
the mode selected.
4. Temp Increase + / Decrease - Pads
Use to set temperature when in Auto, Cool, Dry or Heat
(on some models) mode.
5. Fan Speed
Use to set the fan speed at LOW, MEDIUM, or HIGH.
Indicator lights will show the speed selected.
To ensure proper operation, aim the remote control at
■
the signal receiver on the air conditioner.
The remote control signal has a range up to 21 feet.
■
4
Temp/Timer
Air Conditioner Controls
Lights above the touch pads on the air conditioner
control panel indicate the selected settings.
6. Timer
ON - Use to set the air conditioner to automatically turn ON
from .5 to 24 hours later.
OFF - Use to automatically turn the air conditioner OFF
from .5 to 24 hours later.
7. Filter
Monitors accumulated fan run time as a reminder to clean
the filter.
8. Eco
ON: Use to cycle the fan off when the compressor cycles
off.
OFF: Use to run the fan continuously when in cooling or
heating (on some models) mode.
9. Sleep
Allows room temperature to increase (Cool mode) or
decrease (Heat mode) during sleeping hours.

Remote Control

Make sure nothing is between the air conditioner and
■
the remote control that could block the signal.
Make sure the battery is fresh and installed correctly—
■
see the Care and Cleaning section.
49-5000444 Rev. 0