Dimmer; Led Illuminated Ring; Connections; Headphones - Sonoro iElements Mode D'emploi

8.5 Dimmer

You can also adjust the brightness of the display to your requirements.
When your iElements is switched on, press the menu button and then select the DIMMER
menu item with the << and >> buttons. You can select one of three brightness settings with
the + and - buttons; DIM LO, DIM MI and DIM HI. DIM LO is the darkest setting and DIM HI the
brightest setting.

8.6 LED illuminated ring

Your iElements features an LED illuminated ring with the buttons << and >>. This lights up
as soon as you switch on your iElements and goes out when you switch off your device. You
can also completely deactivate the LED illuminated ring feature.
To change the LED illuminated ring, press the menu button once while the iElements is
switched on. Then select the LIGHT menu item with the << and >> buttons. You can then set
the brightness of the LED illuminated ring of your iElements with the + and – buttons. You
can select either very bright (HIGH), normal (MID) and weak lighting (LOW). To deactivate the
LED illuminated ring, select (OFF).

9. Connections

9.1 Headphones

You can connect headphones to the headphone socket with a 3.5 mm jack plug. Take care
not to confuse the headphone socket with the Aux-In socket.
DANGER!
Avoid using the headphones at a continuously high volume. There is the risk
of permanent damage to your hearing! Take special care that children do not
turn the volume up too high.
21