Selecting A Preset Station; Settings; Time - Sonoro iElements Mode D'emploi

NOTE!
Your iElements has an integrated memory so that your stations will remain
saved even if you disconnect the device from the power supply.

7.4 Selecting a preset station

Your iElements can save up to 10 stations per frequency band in the preset memory.
If you would like to listen to a preset station, switch on your iElements, select the desired
frequency band by pressing the symbol and activate the menu with the menu button.
The MEM CALL function appears on the display and when you have again confirmed your
selection with the menu button, you can select one of the memory presets P 0 to P 9 with the
+ and – buttons. The assigned station frequency is displayed behind the memory preset.
If the memory preset has not yet been assigned, the message FREE is then displayed.
When you have selected the station you would like to listen to, your iElements plays the
saved station.
If you would like to cancel the selection of a station, simply do not press any button for
approx. 5 seconds. Your iElements then returns from the menu to regular playback mode.
NOTE!
Your iElements leaves the works without any preset stations. For this reason all
presets are marked as FREE.

8. Settings

8.1 Time

If your iElements is switched off or if you have not pressed a button for a prolonged period of
time when it is switched on, the time is shown on the display. You can have the time
displayed in a 24 hour format (e.g. 21:20) or in a 12 hour format (e.g. 9:20pm).
To set the time, switch off your iElements. Press the menu button once, select the time menu
item with the << and >> buttons and confirm your selection with the menu button. You then
have the option of selecting either the 24 hour format (24 HR) or the 12 hour format (12 HR)
with the + and – buttons.
After you have confirmed your selection with the menu button, you can switch between the
settings of hours and minutes with the << and >> buttons (the selection flashes) and set the
correct values with the + and – buttons. Finally confirm your selection by pressing the menu
button again.
NOTE!
AM means "ante meridiem" and refers to all times from midnight until 11:59
in the morning. PM means "post meridiem" and refers to all times from noon
until 23:59 at night.
18