Alarm - Sonoro iElements Mode D'emploi

8.2 Alarm

Your iElements can wake you up with a radio station or a pleasant alarm tone. You can set
the volume of the alarm and use the so-called snooze function.
You can set the alarm when the iElements is switched on as well as when the device is
switched off. In both cases press the menu button and then use the << and >> buttons to
navigate through the options until ALARM appears on the display. Confirm your selection by
pressing the menu button.
Now you can activate the alarm (ALM ON) or deactivate it (ALM OFF) with the + and –
buttons and confirm your selection with the menu button. If you select ALM OFF, the setting is
cancelled. You can recognise an active alarm by the small alarm symbol on the display.
When you have selected ALM ON, you can set the wake-up time. This is selected in the same
way as setting the display time with the +/- and <</>> buttons. Confirm your selection with
the menu button.
SOURCE then appears on the display and you can decide which signal you would like to be
woken by. The frequency ranges FM and AM as well as an alarm tone (BEEP) are available.
Make your selection with the << and >> buttons and confirm it with the menu button. If you
select a radio station, you can use the stations you have saved in the presets. Use the + and
- buttons to select from the 10 memory presets 0...9 for each frequency band.
VOLUME then appears on the display and you can select the alarm volume of your signal
source with the + and – buttons. As soon as the alarm starts, the volume is slowly increased
until it reaches the level you have selected. When you confirm your selection with the menu
button, the alarm has been set. ALARM ON appears on the display.
NOTE!
When setting the alarm time, please pay attention to the selected time format.
You can recognise an active alarm by the alarm symbol on the display. Before
using this function for the first time, test the different alarm volumes to find a
level that is suitable for you. If you have connected a device to the
headphones socket, please note that the alarm tone will only be output
through this device. This means, for example, that you may not be able to
hear the alarm if the headphones have slipped. Please make sure that you
switch off the alarm, for example, if you go on holiday.
You can switch off an active alarm by pressing the menu button for approximately two
seconds. The alarm will stop and the small alarm symbol on the display stops flashing.
If you want to temporarily suppress an active alarm rather than turning it off, you can use the
snooze function. Briefly press the menu button once when the alarm is activated. SNOOZE
then appears on the display and you can use the + and – buttons to set the number of
minutes after which the alarm should be switched on again. The default setting is 5 minutes.
Once you have made your selection, please confirm it with the menu button. The small alarm
symbol on the display continues to flash and is reactivated after the time you have set. If you
19