Scheppach HS105 Traduction Des Instructions D'origine page 37

* Operating mode S6 20%: Continuous duty with
intermittent loading (operating time 10 mins). In
order avoid impermissible overheating of the mo-
tor, the motor should be driven for only 20% of the
operating time with the stipulated nominal power
and must then continue to run with no load for the
remaining 80% of the operating time.
Noise level
The noise values have been determined in accordance
with EN 62841.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
Wear hearing protection.
Excessive noise can result in a loss of hearing. Total
vibration values (vector sum of three directions) deter-
mined according to EN 62841.
• The specified noise emission values have been
measured in accordance with a standardised test
procedure and can be used to compare one power
tool with another.
• The specified noise emission values can also be
used for an initial estimation of the exposure.
• Warning:
The noise emission values can vary from the spec-
ified values during the actual use of the power tool,
depending on the type and the manner in which the
power tool is used, and in particular the type of work-
piece being processed..
• Implement measures to protect against noise nui-
sance. In doing so, take into account the complete
working process, including the times when the
power tool is working without load or switched off.
Suitable measures include regular maintenance and
care of the power tool and the insertion tools, regu-
lar breaks as well as proper planning of the working
process.
7. Before commissioning
• The machine must be securely installed, i.e. bolted
down on a workbench, machine stand or similar.
Use the holes in the machine frame for this.
• Prior to commissioning, all covers and safety devic-
es must be mounted correctly.
• It must be possible for the saw blade to run freely.
• In case of previously machined wood, be aware of
any foreign objects, such as nails or screws, etc.
• Before pressing the on/off switch, make sure that the
saw blade is correctly fitted, and that moving parts
run smoothly.
92.6 dB(A)
• Before connecting the machine, make certain that
3 dB
the data on the type plate matches with the mains
power data.
105.6 dB(A)
• Only connect the machine to a correctly installed
3 dB
protective contact socket, with fuse protection of at
least 16A.
8. Attachment and operation
Attention! Remove the mains plug before any
maintenance, modification and assembly work on
the circular saw.
Place all supplied parts on a flat surface. Group equal
parts.
Note: If connections are secured with a screw (round
head/or hexagon), hexagonal nuts and washer, the
washer must be placed under the nut.
Insert screws each from outside to inside. Secure con-
nections with nuts on the inside.
Note: During assembly, tighten the nuts and bolts only
to the extent that they cannot fall off.
If you tighten the nuts and screws fully before final as-
sembly, it is not possible to complete the assembly.
8.1 Fitting the frame (Fig. 5-7)
1. Screw the four legs (17) to the centre struts (20+21)
using the screws (g) and nuts (h).
m Attention!
The top struts have an elongated hole for fastening
to the table!
2. Now screw the lower struts (18+19) loosely to the
legs using the screws (g) and nuts (h) (Fig. 5).
3. Now plug the rubber feet (22) onto the legs (Fig. 6).
www.scheppach.com GB | 37