Assembly - Titan XL255 Mode D'emploi

Do not plug in the power cord until assembly is complete.
If you have one of the cart models (XL295 or XL335) you will need to unfold the cart before using. Follow steps 1-4,
below. If you have the model XL255 sprayer, skip to item 5, below.
1. Grab the pail bracket to lift up
the sprayer. Lift the leg lock and
unfold the legs. Move leg lock
down to lock into place.
4. Insert the ends of the hose bracket into the holes of the
handle as shown.
6. Thread the other end of
the hose to the spray gun.
Hold the gun with one
adjustable wrench, and
tighten the hose nut with
the other.
The spray tip should not
be attached until after the
sprayer and spray hose have
been purged and primed.
8. Press the return tube
onto the return tube
fitting. Squeeze clip over
the return tube fitting to
secure the return tube.
English

Assembly

2. Twist the knob on either side of
the cart toward the "UP" arrow
until it stops.
5. Thread one end of the high pressure spray hose to
the spray hose port. Hold the port with an adjustable
wrench, and tighten the hose with the other.
7. Remove cap from inlet valve
(a). Thread the suction tube
onto the inlet valve and tighten
firmly by hand. Be sure that the
threads are straight so that the
fitting turns freely.
9. Verify that the seal is
present inside the suction
tube. Thread the inlet filter
into the end of the suction
tube.
6
3. Lift the handle until the motor
housing and handle locks into
place. Be careful not to pinch the
power cord with the cart.
(a)