arilex EC665 Instructions Pour L'installation page 77

3.
POSITIONING AND HANDLING
3.5 REMOVAL OF PROTECTION MATERIALS
The outer surfaces of the appliance are protected by a coating of adhesive film, which must be manually re-
moved once positioning phase is over.
Clean the appliance manually removing all the material used to protect its parts.
Make sure not to damage the stainless steel surfaces, and remember especially not to use cor-
rosive products, abrasive material or sharp tools.
Do not clean the appliance with pressurized and/or direct water jets.
Do not use aggressive materials such as solvents to clean the appliance.
Carefully read the indications on the label of the detergent products being used, wear a protective
equipment suitable to the operations to be carried out (See protection means indicated on the
label of the packaging)
Rinse the surfaces with tap water and dry them with an absorbent cloth or other non abrasive
material.
3.6 LEVELLING AND FIXING
Position in the working area (see al-
lowed operational and environmental
conditions), with the different equip-
ments already made suitable.
Levelling and fixing envisage: the equip-
ment adjustment as an individual inde-
pendent unit or, if foreseen, its fixing in
a "series".
Position a level on the structure (detail D).
Adjust the levelling feet (detail E) according to the
indications shown by the level.
The appliance is perfectly levelled when
level and feet are adjusted on the same
width and depth of the appliance.
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
D
- 11 - 11
E
E