General Safety Information - arilex EC665 Instructions Pour L'installation

2.
GENERAL AND SAFETY INFORMATION
General safety indications
Each technical modification affects the machine functioning or safety, therefore, it must be
carried out by the manufacturer technical staff or by technicians who has been formally
authorized by the same manufacturer. Otherwise, the manufacturer refuses all responsibil-
ity concerning modifications or damages which could be consequently rise.
On arrival of the delivery, check the integrity of the appliance and of its components (eg.
Supply cable), before use, if any fault should arise, do not start the appliance and contact
the nearest customer service.
Before performing the connections check the technical data mentioned on the appliance
plate, as well as the technical data mentioned on this manual.
On the supply lines (Electrical-Water-Gas) upstream the machine, install interlock devices
which cut out the supply each time the user must operate in safe conditions.
Connect the appliance, in order, to the waterworks and to the drainage system, then to the gas
network, make sure there are no leaks then go on with the connections to the electric network.
The appliance has not been designed for the operation in an explosive atmosphere, there-
fore it mustn't absolutely be installed and used in such environments.
Position the whole structure following the installation characteristics mentioned in the spe-
cific chapters of this manual.
Note!
•
The equipment has not been designed for an embedding installation.
•
The equipment must operate in thoroughly ventilated rooms.
•
The equipment drains must be free (not obstructed or blocked by foreign matters).
The gas appliance must be placed under a suction hood, which system must be endowed
with the technical features complying with the standards in force in the country of the user.
Once the equipment has been connected to the energy and drain sources, it must remain
static (not movable) in the area which has been foreseen for use and maintenance. An
improper connection may give rise to a dangerous situation.
If necessary, for the connection to the electrical line use a flexible cable which character-
istics comply with those of the cable with rubber insulation, model H07RN-F. The supply
voltage supported by the cable, with the appliance on, must not diverge from the rated
voltage value ± 15%, mentioned at the bottom of the technical data table.
The equipment must be included in an "Equipotential" earth unload system.
The appliance drain must be conveyed into the grey water drainage system, with a "spigot
and socket" pipe with no trap.
The equipment must be used only for the indicated purposes. Any other use must be
considered as "IMPROPER" and therefore the manufacturer refuses all responsibility for
possible consequent damages to persons or things.
Special safety prescriptions (Obligations-Prohibitions-Dangers) are mentioned in detail in
a specific chapter concerning these issues.
Do not obstruct the heat extraction and/or dissipation openings.
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
- 6 - 6