arilex EC665 Instructions Pour L'installation page 76

3.
POSITIONING AND HANDLING
3.1 FOREWORD
Depending on the cases, the appliance is shipped in the fol-
lowing configuration:
1.
Blocked on the wooden base, with lining in a material suit-
able for packaging (detail A).
The type of packaging is chosen according to transport dis-
tance, to the customer prescriptions and to how long the ap-
pliance will remain in the package.
The following data will be applied on the package:
•
destination
•
possible codes
•
safety pictograms
•
instruction pictograms
The machines can be transported with two means:
with truck
with container.
The same type of package is foreseen in both cases.
3.2 HANDLING - TRANSPORT
The packed appliance must be positioned in order
to keep to the indications given in the pictograms
and in the writings on the package outer wrap.
Do not wait or pass under the equipment while it
is being lifted and handled. The noncompliance
with these instructions exposes the operator to
the danger of serious injuries.
•
Position the hoisting equipment: take care to the barycen-
tre of the load to be lifted (detail B - C).
•
Lift the appliance enough to allow its handling.
•
Position the appliance in its standing place.
3.3 STORAGE
Material storage methods must envisage pallets, containers,
conveyors, vehicles, lifting tools and devices, which can pre-
vent any damage caused by vibrations, bumps, abrasions,
corrosions, temperature or any other possible conditions.
The stored parts must be checked periodically
to identify any possible damage.
3.4 PACKAGE REMOVAL
The addressee is in charge of the disposal of the packing materials, which must be elimi-
nated according to the laws in force in the appliance installation country.
1. Remove the protection angle bars, first the upper and then the lateral ones;
2. Removed the protective material used for the package.
3. Lift the appliance at the necessary height and remove the base;
4. Position the appliance on the floor.
5. Remove the means used to lift the appliance.
6. Clear the operating area from all the material that has been removed.
Once the packaged has been removed, the appliance must appear free of tampering,
dents or other defects. Otherwise, immediately inform the assistance service.
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
A
B
- 10 - 10
ABC
C
ok!