Publicité
Les langues disponibles
Les langues disponibles
•
When measuring volts, do not switch to current/resistance
modes.
•
Set the function switch to the appropriate position before
measuring.
•
Set the function switch (K) to the OFF position when not in
use.
•
When changing ranges always disconnect the connector
leads from the circuit under test.
•
Always discharge capacitors and remove power from the
device under test before performing diode, resistance or
continuity tests.
•
Voltage checks on electrical outlets can be difficult and
misleading because of the uncertainty of connection to the
recessed electrical contacts. Do not use this product for
checking socket outlets. Use special equipment for checking
socket outlets.
•
Comply with all applicable safety codes. Use approved
personal protective equipment when working near live
circuits − especially with regard to the possibility of arc flash
hazards.
•
Inspect the condition of the connector leads and the product
for any damage before operation. Replace any damaged
accessory before use. Consult a professional repair centre
for any other repairs.
•
The light source in this product is not replaceable.
•
Do not look directly into the light source.
•
Always remove the connector leads before replacing the
battery.
EN
5
Publicité
