Worx WG252 Mode D'emploi page 12

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
Intended Use
The machine is intended for cutting and trimming
hedges and bushes in domestic use.
ASSEMBLY & OPERATION
ACTION
BEFORE OPERATION
Installing the battery pack
Removing the battery pack
Checking the battery condition
NOTE: Fig. A3 only applies for the battery
pack with the battery indicator light.
Charging the battery pack
More details can be found in charger's
manual
ASSEMBLY
Attaching and releasing the extension
pole
12
Extending the inner pole
Rotating rear handle
NOTE:The cutting angle can be
adjusted between 0
WARNING: Always make sure
that the handle is locked in the
desired position before
operation. Do not rotate the handle
when the trimmer is being operated.
Adjusting the head angle
WARNING: Failure to properly
secure the trimmer head may
result in personal injury and/or
property damage.
OPERATION
Removing the blade sheath
Starting and Stopping
Top cutting
WARNING: If any parts are
missing, damaged or broken, do
not operate your hedge trimmer
until all damaged parts have been
replaced or repaired. Failure to do so
could result in serious personal injury.
Cordless Pole Hedge Trimmer
FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. A4
See Fig. B1,
B2
See Fig. C
-90 left or right.
0 0
See Fig. D
See Fig. E
See Fig. F
See Fig. G
See Fig. H1
Side cutting
WARNING: Stop operating the
trimmer before rotating the
handle.
Lubricating the cutting blade
NOTE: It is important to use only the
recommended standard lubricating oil
(WD-40) to avoid damage to the blade.
HOW TO USE YOUR HEDGE
TRIMMER
Before cutting an area, inspect it frst and remove
any foreign objects that could become thrown or
entangled in the blades.
Always hold the trimmer with both hands and with
the blade away from you before turning it on.
When trimming new growth, use a wide sweeping
action so that the stems are fed directly into the blade.
Allow the cutting blades to reach full speed before
cutting. When operating, keep the cutting blades
away from people and objects such as walls, large
stones, trees, vehicles, etc.
If the blade stalls, immediately stop the trimmer.
Release the two Switch Levers before attempting to
clear jammed debris from the cutting blades.
Wear gloves when trimming thorny or prickly growth.
Do not attempt to cut stems that are too thick for the
cutting blade.
Top cutting
Use a wide sweeping motion. A slight downward tilt
of the cutting blades in the direction of motion gives
the best cutting results.
Side cutting
When trimming the sides of the hedge, begin at the
bottom and cut upwards, tapering the hedge inward
at the top. This shape will expose more of the hedge,
resulting in a more uniformed growth.
MAINTENANCE
Remove the battery from Hedge trimmer
before carrying out any adjustment, servicing
or maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust.
See Fig. H2
See Fig. I
EN