Program Or Cancel Cleaning Schedules; Temperature Display - Polaris Alpha iQ Manuel Du Propriétaire

2. You can direct the cleaner using the remote
control or use the spot clean feature (not
available on all models) to help pick up
*
debris.
3. To use "Spot Clean" drive the cleaner near
where debris has collected and initiate "Spot
Clean." The Cleaner will perform a short
cleaning pattern to remove debris in that
area.
✳ not available on all models
NOTE: If you experience significant delays between the
app command and cleaner response, you may
have a weak Wi-Fi signal or other connectivity
challenges that interfere with the immediacy of
the remote control functions.
Lift System
The Lift System is designed to assist in retrieving
the robot from the pool. Lift System can be activated
at any time during or after a cleaning cycle.
IMPORTANT: Only use Lift System when in view of the cleaner.
1. From the main screen, select
System to enter automated procedure.
Use the left and right arrow icons to rotate
2.
the cleaner to face the wall of your choice.
3. Press the Lift System icon to drive the
cleaner up the wall it is facing. The cleaner
will wait at the water line to be retrieved.
NOTE: To stop the procedure at any time, press and release
the button again.
4. When in reach, grab the cleaner handle and
begin to pull cleaner out of the water. The
cleaner will quickly expel water to allow for
lighter, easier removal.
NOTE: Never lift the cleaner out of the pool by the floating
cable.
Program or Cancel Cleaning
Schedules
(not available on all models)
It is still recommended to remove and clean the
filter canister after every cleaning cycle.
1. Tap the area titled Next Cleaning or
go to System Settings
Schedules.
2. To program a schedule, select the day of
the week.
3. Select a start time to begin the cleaning
cycle.
4. Select a cleaning mode. Mode selected will
determine runtime.
Press OK to save the schedule or Delete to
5.
remove permanently.
6. Repeat steps 2-4 to program additional
days.
NOTE: Only one programmed cleaning cycle can be
scheduled per day.
Press BACK or DONE to leave the Edit
7.
Schedule page and return to the main
Lift
screen.
8. The next scheduled cleaning cycle will
display near the top of the main screen.

Temperature Display

(not available on all models)
On some models, the pool water temperature will
be displayed on the main app screen. Accurate
temperature may take a few minutes to display as
the sensor acclimates to the surrounding water
temperature. Temperature will only be displayed
during an in-progress cleaning cycle.
LED Lights
1. Sensor Nav System™ - Indicator Light:
Located on the front of the cleaner, this light
has several functions to indicate status:
Blinking Blue - Sensing, Scanning and Cleaning
Solid Blue - Cleaning
*
Blinking Green: Lift System or Spot Cleaning
Page 15
and choose