Iaqualink Control; Iaqualink™ Control Home Screen; Start / Stop Cleaning And Adjust Cleaning Time; Set Cleaning Mode - Polaris Alpha iQ Manuel Du Propriétaire

Page 14
6
iAquaLink
Control
Once you have downloaded the iAquaLink
app and connected the device to Wi-Fi, the
iAquaLink app allows for robotic cleaner control
from anywhere, anytime. Functions vary within
the iAqualink app depending on which cleaner
model you have.
WARNING
Do not enter pool while the robotic cleaner
is in water.
iAquaLink™ Control Home Screen
App function and design is subject to change.
Start/Stop Cleaning
Remote
Clean Mode
Lift System
Start / Stop Cleaning and Adjust
Cleaning Time
The factory default cleaning surface setting is
SMART Cycle (Floor, Wall, Waterline).
SMART Cycle calculates a customized cleaning
time optimized for your pool. On the first run
of SMART Cycle, the app counts up as it
calculates the optimized cleaning time.
On periodic SMART Cycle cleaning, the app will
count down from the optimized cleaning time.
™
Dirty Canister Indicator
+
+
Manual Time Adjustment
_
(current run time +/- 15 minutes)
_
°C / F Water Temperature
Display
NOTE: To Recaculate SMART Cycle, go to the Set
Cleaning Mode after the initial calculation.
1. From the Home screen or the Control Box,
press the Start button to begin
cleaning.
2. The app displays the cycle time in hours
and minutes.
To increase or decrease the cycle time
during cleaning,
press the (+) and (–) buttons.
-Time adjusts up or down in 15 minute
increments.
-Minimum run time is 30 minutes.
-Maximum run time is 3 hours 30 minutes.
-The control box displays the same countdown
and cycle setting as the app.
3. Press to interrupt and cancel an in-
progress cleaning cycle.
NOTE: At the beginning of each cleaning cycle, the robot
confirms your pool parameters (approximately 10
minutes). During this time, the cleaner does not
climb to the waterline.

Set Cleaning Mode

From the main screen, select Cleaning
1.
Mode to view options.
*
2. Choose from available cleaning modes
depending on your cleaner model.
3. In Custom mode (if applicable), select the
cleaning surface and cleaning intensity
from the on-screen icons.
✳ not available on all models

Remote Control

Use your mobile device as a remote control.
IMPORTANT: Only use Remote Control when in view of the
cleaner.
From the main screen, select the Remote
1.
tab.
NOTE: When in remote control mode, the control box
displays .