Installation: Triango 80 Luminaire Head; Operation - Derungs Dmed Triango 80 C Mode D'emploi

ENG
6. INSTALLATION: Triango 80 luminaire
head
DANGER
Death hazard from electric shock.
►
When performing any work on the device, disconnect
it from the power supply or pull the plug out of the
socket and secure the device from being switched on
again
WARNING
Injury hazard
►
The spring balanced arm is under high spring stress.
If the boom is lowered without the installed device, it
MUST be held firmly.
►
If it is let go, it springs upward and can cause severe
injury.
►
Never remove the luminaire body unless the boom is
in the upper position or is held securely in low
position by a second person.
►
To prevent severe injury or damage, always get the
help of a second person when installing and
removing the luminaire body.
Remove screw "A" and pull off the yellow protection cap
►
"B" from the spring arm safety device.
►
Attach the luminaire head.
►
Turn the sleeve to insert the locking device.
34
A
B
►
Turn the sleeve back the other way and secure with a
screw.
WARNING
Injury hazard from falling luminaire head.
►
Make sure the locking device is properly installed.
►
Damage to due to a poorly mounted luminaire head.
Tighten the screw as the luminaire head's friction
►
requires.
►
Attach the hand grip.
7.

OPERATION

Triango 80 C, W, F
CAUTION

This product emits potentially hazardous optical
radiation. Do not stare directly into the light cone.
Eye irritation may occur.

The radiation emitted by this product complies with
the exposure limits for reducing the risk of
photobiological hazards based on IEC 62471: RG 2
(medium risk).
►
Turn the luminaire on with the rotary knob.
►
The luminaire can be dimmed by turning the head.
►
Before each use, perform a functional test: All LEDs in
the light cone must come on.
CAUTION
►
The rotary knob is not removable.