ENG
►
After inserting the wall mounting arm, first install the ring
"A", then the locking ring "B", followed by the end rings
"C".
D
Carefully insert the rotary plug "D".
►
B
A
C
Attach the joint covers "B" and install the screws "C".
►
Attach the covers "A".
►
DANGER
Death hazard from electric shock.
►
Do not turn on the power supply before the luminaire
head has been installed.
►
To proceed with installation of the luminaire head, see
Chapter 6.
32
A
B
C
A
5.
INSTALLATION: Triango 80 F
►
Remove the M3 screws at the sides and then remove
the power supply unit tub "A".
►
Unfasten the two screws on the lower standpipe.
►
Feed the support tube cable through the roller stand.
►
Attach the support tube to the roller stand using the two
Allen screws and serrated washers (10 Nm).
►
The cable holder must be aligned rearward.
►
Connect the same-colored stranded wires of the lower
support tube and of the power supply.
►
Mount the power supply unit tub again using M3 screws
and serrated washers.
Carefully pull off the covers "A".
►
A
A