Installing The Ceiling Tube - Derungs Dmed Triango 80 C Mode D'emploi

ENG
►
Draw 6 drill marks.
Observe the position of opening "A" for connecting the
►
current.
WARNING
Wear safety equipment
manufacturer's instructions.
►
Drill holes and blow out with a bellows.
135 mm
270 mm
►
Check the hole distances.
►
Hold the ceiling bracket to the ceiling and hammer in
the fastening anchor.
Tighten the fastener according to manufacturer's
►
instructions.
DANGER
Death hazard from electric shock.
►
Do not turn on the power supply before the luminaire
head has been installed.
►
This device must only be connected to a power grid
with a protective ground conductor (PE) to prevent
risk of electric shock
28
A
according to the tool
►
Connect the power.

3.4. Installing the ceiling tube

A
Pull the ceiling tube cable through the opening "B" of
►
the ceiling holder.
Insert the ceiling tube "A" into the ceiling holder.
►
Secure the safety screw "C"and the M8 nut.
►
D
Tighten the M8 safety screw "C" and the nut (20 Nm).
►
Tighten all 4 grub screws "D" (5 Nm).
►
►
Connect the ceiling tube plug with the power supply
plug.
►
Slide the ceiling cover and ring over the ceiling bracket
and screw them tight.
B
C
C