Caring For The Environment; Information For Control Bodies - F.Bertazzoni Professional Serie Mode D'emploi

1. IMPORTANT DIRECTIONS FOR SAFETY AND THE ENVIRONMENT

1.3 Caring for the environment

> This appliance conforms to the WEEE European
directive (2012/19/EU) and must be disposed of
separately from other waste at the end of its service
life.
> The appliance does not contain substances in
quantities sufficient to be considered hazardous
to health and the environment, in accordance with
current European directives.
> Pay special attention to correct disposal procedure
for all the packaging materials.
Power voltage
Danger of electrocution
Disconnect the mains power supply.
Unplug the appliance.
> The appliance must not be disposed of with urban
waste. Contact local waste disposal centres for how
to dispose of recyclable waste.
> Prior to disposal, cut the power supply cord and
make it impossible to close the door.
> During disposal, avoid damage to the refrigeration
circuit.
> The appliance does not contain hazardous
substances for the atmospheric ozone layer, neither
in the refrigeration circuit nor in the insulation.
>
Our appliances are packaged in non-polluting and
recyclable materials.
> Deliver the packing materials to the appropriate
recycling centre.
4
Plastic packaging
Danger of suffocation
Do not leave the packaging or any part
of it unattended.
Do not let children play with the plastic
bags.
Warning
To avoid contamination of food, please
respect the
> Opening the door for long periods can cause
a significant increase of the temperature
in the compartments of the appliance.
> Clean regularly surfaces that can come in
contact with food and accessible drainage
systems.
> Store raw meat and fish in suitable
containers in the refrigerator, so that it is
not in contact with or drip onto other food.
> If the refrigerating appliance is left emp-
ty for long periods, switch off, defrost, cle-
an, dry, and leave the door open to prevent
mould developing within the appliance.

1.4 Information for control bodies

> For EcoDesign checks, the installation and
preparation of the appliance must comply with EN
62552 standard.
> Ventilation requirements,
minimum space from the rear wall are indicated in
the "Installation" chapter of this manual.
>
Contact the manufacturer for more information.
following instructions:
dimensions and