Malfunction: Causes And Solutions - Sanremo CUBE V Livret D'instructions

CUBE

MALFUNCTION: CAUSES AND SOLUTIONS

8 MALFUNCTION: CAUSES AND SOLUTIONS
MALFUNCTIONS, CAUSES - SOLUTIONS
Following is a list of some of the inconveniences that may occur when using the machine.
For all problems not included in this table, please contact the Technical Assistance Service.
PROBLEMS
Water is not dispensed by the
unit
Water does not heat up
There is a leak from the steam
wand with the tap closed
Steam is leaking under the tap
knob during opening
Insufficient use of coffee
During dispensing a leakage
occurs between the unit and
the filter holder
Coffee overflows from the
edges of the filter holder
Coffee is too cold
The machine does not dispense
hot water
CAUSES
The water mains tap or the impurity
filter taps are closed.
The water intake union filter is
clogged
Clogged Gigleur
Burnt out resistor
Safety thermostat tripped
Defective gasket
Faulty tap axis gasket
The grain size of ground coffee is not
correct (too fine or too coarse grain)
Partially clogged head and filters
Incorrect unit temperature
Defective cup gasket or uneven filter
edge
Dirty residues are present in the seat
of the filter holder, preventing coffee
from flowing through the spout
Unit gasket worn out
Clogged heads
Machine not ready
Supply tap closed
Faulty dispensing solenoid valve
Clogged dispensing ducts
Malfunction: causes and solutions
SOLUTIONS
Open the tap
Disassemble and clean. Check regeneration
of the impurity filter resins
Call the technical service
Call the technical service
Call the technical service
Call the technical service
Call the technical service
Check the grinding time and/or adjust
grinding
Call the technical service
Call the technical service
Call the technical service
Clean
Replace
Clean or replace
Wait for the temperature to be reached
Open the tap
Call the technical service
Call the technician to perform a limescale
removing cleaning
50