Mounting And Adjusting The Leaves - Key Automation WIND Instructions Et Avertissements Pour L'installation Et L'usage

EN

4.4 - Mounting and adjusting the leaves

The leaves and adapter profile should be assembled in the workshop;
assembly on the worksite is not recommended.
A reinforcement should be fitted on the leaf crosspiece. Do not use
self-tapping screws when fitting the adapter; fix it with M6 metric
screws or fit push-in threaded inserts into the aluminium profile about
every 30 cm.
The head of the screw must be no more than 6 mm high.
The distances shown below must be complied with when fixing the
carriages; the measurements are different for single or double door
automation systems.
DOPPIA ANTA WIND / WIND LIGHT
A1sx
ANTA SINGOLA APERTURA SX ANTA SINGOLA APERTURA SX
WIND / WIND LIGHT WIND / WIND LIGHT
SINGLE DOOR OPENING TO L WIND / WIND LIGHT
A1sx A1sx
WIND LIGHT DOUBLE DOOR
WIND LIGHT SINGLE DOOR OPENING TO L
WIND LIGHT SINGLE DOOR OPENING TO R
WIND DOUBLE DOOR
WIND SINGLE DOOR OPENING TO L
WIND SINGLE DOOR OPENING TO R
26
WIND / WIND LIGHT DOUBLE DOOR
A1dx
A1
SINGLE DOOR OPENING TO R WIND / WIND LIGHT
A1dx A1dx
A1sx
80
60
120
62
100
100
M 6
A2sx
A2
ANTA SINGOLA APERTURA DX ANTA SINGOLA APERTURA DX
WIND / WIND LIGHT WIND / WIND LIGHT
A1sx A1sx
A1dx
60
80
140
24
100
100
(24 ONLY FOR
LT > 4200)
TOP ADAPTER
PROFILE PA020
50
23
A2dx
A1dx A1dx
A2sx A2dx
60 80
- -
- -
24 62
- -
- -