Safety; Intended Use - Festo SPAW B2R Mode D'emploi

1. General information / 2. Safety
Abbreviations
U Positive power terminal
B
0V Negative power terminal
A Analogue output
Out
SP1 Switch point 1 / Switching output 1
SP2 Switch point 2 / Switching output 2

2. Safety

WARNING!
Before installation, commissioning and operation, ensure that the appropriate pressure sensor has been
selected in terms of measuring range, design and specific measuring conditions.
Non-observance can result in serious injury and/or damage to the equipment.
WARNING!
Open the connections only after the system has been depressurised.
■
Observe the working conditions in accordance with Chapter 3 "Specifications".
■
Always operate the pressure sensor within the overpressure safety range.
■
Further important safety instructions can be found in the individual chapters of these operating instructions.

2.1 Intended use

The pressure sensor is used to convert pressure into an electrical signal indoors and outdoors.
The device is intended for use in an industrial environment. In residential areas, measures for radio interference
suppression may have to be taken.
The technical specifications contained in these operating instructions must be observed.
The manufacturer shall not be liable for claims of any type based on operation contrary to the intended use.
Pressure sensor SPAW
OI_14070935_SPAW_GB_D_F_E.indd 5
EN
5
05.08.2013 11:02:25