Transport, Packaging And Storage; Commissioning, Operation - Festo SPAW B2R Mode D'emploi

5. Transport, packaging and storage / 6. Commissioning, operation

5. Transport, packaging and storage

5.1 Transport
Check the instrument for any damage that may have been caused by transport.
Obvious damage must be reported immediately.
5.2 Packaging
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change in installation site).
5.3 Storage
Permissible conditions at the place of storage:
Storage temperature: -20 ... +80 °C
■
Humidity: 45 ... 75 % relative humidity (no condensation)
■
WARNING!
Before storing the instrument (following operation), remove any residual media. This is of particular impor-
tance if the medium is hazardous to health, e.g. caustic, toxic, carcinogenic, radioactive, etc.

6. Commissioning, operation

CAUTION!
Only use the pressure sensor if it is in perfect condition with respect to safety.
Leaking fluid is indicative of damage.
Required tool: SW 27 open-ended spanner
Pressure sensor SPAW
OI_14070935_SPAW_GB_D_F_E.indd 11
EN
11
05.08.2013 11:02:26