Festo SPAW B2R Mode D'emploi page 15

6. Commissioning, operation
6.6 Parameters
Parameter Description
SP1/SP2 Hysteresis function: Switch point switching output (1 or 2)
FH1/FH2 Window function: Window high switching output (1 or 2)
RP1/RP2 Hysteresis function: Reset point switching output (1 or 2)
FL1/FL2 Window function: Window low switch output (1 or 2)
EF Extended programming functions
RES Return the set parameter to the factory settings
Switch delay time, which must occur without interruption before any electrical signal change occurs (SP1 or SP2)
DS1/DS2
DR1/DR2 Switch delay time, which must occur without interruption before any electrical signal change occurs (RP1 or RP2)
OU1 Switching function switching output (1 or 2)
OU2 HNO = hysteresis function, normally open
HNC = hysteresis function, normally closed
FNO = window function, normally open
FNC = window function, normally closed
UNIT Changing units
(If the measuring range is outside the indication range, a unit switching is not possible and the UNIT parameter is not
indicated)
0SET Offset adjustment (3 % FS)
DISM Display value in display mode
ACT = actual pressure value; LOW, HIGH = minimum, maximum temperature value; SP1/FH1 = function switch point 1;
RP1/FL1 = function reset point 1; SP2/FH2 = function switch point 2; RP2/FL2 = function reset point 2;
OFF = display off
DISU Display update 1, 2, 5, 10 updates/second
DISR Rotate display indicator by 180°
RHL Clear the Min- and Max-value memories
PAS Password input, 0000 = no password
Password input digit by digit
TAG Input of a 16-figure alphanumeric measuring point number
Pressure sensor SPAW
OI_14070935_SPAW_GB_D_F_E.indd 15
EN
15
05.08.2013 11:02:26