cecotec CONGA 899 SLIM Manuel D'instructions page 25

Relevant details are listed below.
RED LIGHT BLINKS:
Nº Prompt tone
01
02
03
RED LIGHT STAYS ON ALL THE TIME:
Nº Prompt tone
01
02
03
NOTE. If the abnormalities cannot be solved by the above-mentioned methods, please try the
following operation:
1. Turn off the power switch at the bottom of the machine and restart.
2. If restarting fails to solve the problem, please send the machine to after-sales centre for
maintenance.
SPECIAL TIPS:
1. Functional disturbances can occur and abnormalities can appear if the voltage of the battery
is too low. In that case the machine should be put on the home base manually.
2. The machine has a protection function for excessive discharge and will automatically cut off
the power supply when the battery voltage is too high.
3. The machine will automatically enter the charging mode when the battery runs out of charge.
The charging time may be up to 12h.
7. TECHNICAL SPECIFICATIONS
Model: Conga 899 Slim
Product reference: 05094
Voltage: 10.8 V
Power supply: 17 W
Reasons
The collision plate is abnormal. Check if the collision plate is stuck
The cliff sensors are
abnormal.
Other abnormalities.
Abnormality. Reasons
The driving wheel is
abnormal.
The side brushes are abnormal.
The fan is abnormal.
Solutions
with foreign particles.
The cliff sensors are dirty, please
clean them up.
Voltage is too low and artificial
assistance is needed, or the power
switch is off while charging.
Solutions
Rotate the wheel and check if it
gets stuck.
Check if the side brushes get stuck
or are entangled; please clean the
side brushes.
Clear the rubbish in the dust bin
and clean the suction channel.
CONGA 899 SLIM
ENGLISH
25