Prepare The Site; Prepare The Whirlpool - Kohler K-1360 Mode D'emploi

Whirlpool
Rim
Drop-In Installation
Allow for the thickness of
the planned deck material.
Whirlpool
Rim
Wood
Batten
Flush Installation

1. Prepare the Site

CAUTION: Risk of product damage. Do not support the whirlpool by the rim.
NOTICE: Adequate floor support must be provided. Consult the roughing-in sheet packed with your
whirlpool for specific floor loading requirements.
Make sure the flooring offers adequate support for your whirlpool, and verify that the subfloor is
flat and level.
The whirlpool can be installed in a drop-in, flush, alcove, or tile-in installation. Construct 2x4 stud
framing designed for your particular installation. Frame the floor, or construct a frame for a raised
installation in accordance with the roughing-in information packed with the whirlpool.
Use the template packed with the whirlpool to carefully lay out and cut the rough deck material.
For flush-mount installation, allow for the thickness of the planned deck material.
Position the plumbing according to the roughing-in information packed. Cap the supplies, and
check for leaks.

2. Prepare the Whirlpool

Install the drain to the whirlpool according to the drain manufacturer's instructions. Do not connect
the trap at this time.
Position a clean drop cloth or similar material in the bottom of the whirlpool. Be careful not to
scratch the surface of the whirlpool.
Kohler Co.
Do not support
the whirlpool
by the rim.
Use the roughing-in
information to
construct the stud
framing.
5
Whirlpool
Rim
Alcove Installation
Furring Strip
Planned Wall
Material
Whirlpool
Rim
Use the roughing-in
information to
construct the stud
framing.
Tile-In Installation
1022211-2-C