LD Systems WS1G8 Manuel D'utilisation page 13

CHANNEL SCAN fUNCTION
Push the SET button, hold it for 1 second and press SET again twice. CHANNEL, AUTO and 2 digits below blink.
Push the Up or Down button to start the channel scan process. After scanning is complete, the display shows the
automatically selected interference free channel.
When using multi-systems and frequency selection is done by the channel scan function, already set up systems
should remain switched on for further channel scan processes. The frequency scan function relates to the
frequency presets in the pre-selected group (01 - 16).
The accuracy of the scan result depends on the environment and the number of simultaneously used wireless
systems. If the scan function does not recognize an already used frequency under adverse conditions, start the
scan process again until an open frequency has been located.
Note: Each frequency channel must come from the same group (01 - 16) when using multi-systems.
Important: Do not operate more than one wireless system on the same frequency at the same time and location.
This causes unwanted loud noise due to radio interference.
AUTO
SqUELCH
The squelch function eliminates unpleasant noise when the transmitter is switched off. It also suppresses sud-
den noise when there is no longer sufficient transmission power received by the receiver.
Adjust the squelch (with transmitter switched off) to the lowest possible setting that suppresses unwanted noise.
Recommended setting for standard applications is „L". Setting "H" can cause smaller distance of transmission
path under unfavourable conditions.
Push the SET button, hold it for 1 second and press SET again 3 times. SQUELCH and the symbols above blink.
Push the Up and Down buttons to adjust the desired setting (L = Low, M = Mid, H = High). Press SET again to
confirm.
The display will return to standard after a short period of time of non-activity automatically.
CAUTION: Set the volume of the connected PA system to a minimum before adjusting the squelch function!
AUTO
SYSTEM SETTINGS:
13