EINHELL 41.330.00 Instructions D'origine page 13

6. Operation
Unscrew the tank cover, fi ll it with lacquer or paint
and reseal it. Connect the compressed air supply.
Set the air pressure on the compressor's pressure
reducer. A fi lter pressure reducer must be used
for coating lacquer so as to remove oil and water
residue from the compressed air.
Adjust the rotary nozzle (2) to suit the direction of
movement during coating. The required distribu-
tion and application volume can be set using the
point / wide cone regulator (3) and the volume
regulator (4).
The infi nitely variable trigger lever (5) allows an
exact dosing of the spray material. The further you
press the trigger lever (5), the more material will
be added to the compressed air. The maximum
volume of coating material can be limited using
the volume regulator (4).
Tip: Before starting work you should conduct a
brief test on newspaper to fi nd the perfect set-
tings. The best results can be achieved if you
apply the material in several coatings, applying
it using alternate horizontal and vertical move-
ments. Maintain a constant distance from the
workpiece to ensure uniform results and also
press the trigger lever whilst swinging the unit
right up to and beyond the edge of the workpiece
to prevent visible bare patches.
7. Cleaning, maintenance and
ordering of spare parts
Warning! Disconnect the air tool from the com-
pressed air source before cleaning.
Important! Do not fully immerse the tool in sol-
vent.
7.1 Cleaning
•
Clean the nozzle as well if it becomes
clogged unexpectedly or the spray pattern is
poor.
•
We recommend that you clean the appliance
immediately after you use it.
•
Clean the accessories after use with a suitab-
le cleaning agent (observe the instructions on
the working materials).
Anl_Farbspritzpistole_Fliessbecher_SPK9.indb 13
https://tm.by
Интернет-магазин TM.by
GB
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
8. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
The reprinting or reproduction by any other me-
ans, in whole or in part, of documentation and
papers accompanying products is permitted only
with the express consent of the iSC GmbH.
Subject to technical changes
- 13 -
08.05.2018 11:07:12