Ozone MOJO Manuel De Vol page 14

all lower A+B lines and 6 G for all lower remaining lines, calculated
from the maximum certified flying weight of the glider. The added
minimum strength for middle lines and top lines is the same.
If the breaking strength is too close to the minimum value calculated,
the professional will give a period after which you'll have to test the
strength of the lines again.
Lengths of the lines - The overall length (riser lines + mid lines +
upper lines) has to be checked under 5DaN of tension.
The difference between the measured length and the original length
should not exceed +/- 10mm.
The changes that could appear are a slight shrink on the C and a
slight stretch on the A, B. The consequences of these changes can
include a slower trim speed, difficult inflation etc.
Full check - A full visual check should be carried out: All the
components of the wing (stitching, ribs, diagonals, lines, tabs, ...)
should be checked.
Finally, if in doubt, a flight test that confirms that the wing behaves
normally can be done by the professional..
IMPORTANT : Take care of your glider and make sure you have it
checked according to the above schedule: This will ensure you hours
of safe flying.
:: MODIFICATIONS
Your Ozone Mojo was designed and trimmed to give the optimum
balance of performance, handling and safety. Any modification means
the glider loses its certification and will also probably be more difficult
to fly. For these reasons, we strongly recommend that you do not
modify your Mojo in any way.
:: OZONE QUALITY & SERVICE
At Ozone we take the quality of our products very seriously, all our
gliders are made to the highest standards in our own manufacturing
facility. Every glider manufactured goes through a stringent series of
quality control procedures and all the components used to build your
glider are traceable. We always welcome customer feedback and are
committed to customer service.
problems not caused by general wear and tear or inappropriate use.
If you have a problem with your glider please contact your
dealer/distributor who will be able to decide upon the most
appropriate action. If you are unable to contact your dealer then you
can contact us directly at info@flyozone.com
14
We will always undertake to fix