Cembre NR-13E Notice D'utilisation Et Entretien page 6

ENGLISH
3.1) Control grip
The control grip has been designed to
provide easy and comfortable access to
the operating buttons both in vertical
and horizontal positions (Ref. to fig. 8,
9). Refer to fig. 2 and operate as follows:
Horizontal use - Hold the control grip so
as to use SAFETY INTERLOCK (15H) and
OPERATING BUTTON (02H).
Vertical use - Hold the control grip so
as to use SAFETY INTERLOCK (15V) and
OPERATING BUTTON (02V).
To avoid accidental start, the safety
interlock must always be pressed before
the operating button is activated.
Always disconnect the power supply before any intervention on the machine, changing
accessories, maintenance etc.
Any accessory (extension, adapter, joint, socket) must be specified for use with impact tools.
The use of unsuitable accessories could lead to breakage.
3.2) Assembly / disassembly of sockets (available separately)
The wrench is preset to receive sockets available on the market having the following features:
– Specified for impact tooling.
– Assemble on to 25.4 mm (1") square shaft with through bore.
Before use, always check to make sure the socket shows no signs of breakage or particular
wear. If the socket does not fit tightly on the square shaft this could result in a loss of power and
excessive wear of components.
To assemble the socket (Ref. to Fig. 7 page 52):
1 Slide the socket onto the square shaft (08) lining up the bores of the socket and the shaft (Ref. to
Fig. 7a).
2 Fully insert the central split pin of "CLIP-NR" into the through bore, ensuring the sprung arms are
correctly located in the slot around the socket (Ref. to Fig. 7b).
To disassemble the socket, extract "CLIP-NR" by simultaneous lateral pushing on both ends of the
sprung arms (Ref. to Fig. 7c).
Keep the "CLIP-NR" in a safe place to avoid loss or damage.
3. INSTRUCTIONS FOR USE
02H
15H
02V
FIG. 2
01
15V
6