Cembre NR-13E Notice D'utilisation Et Entretien page 5

01 – CONTROL GRIP
02 – OPERATING PUSH BUTTON
03 – TRANSPORT HANDLE
04 – IMPACT UNIT
05 – SQUARE DRIVE SHAFT
06 – ELECTRIC PLUG
07 – GEAR/NEUTRAL SELECTOR ( L N R)
08 – ELECTRICAL SAFETY DEVICE
09 – ELECTRICAL CONTROL BOX
10 – TRANSPARENT OIL LEVEL PORT
11 – ELECTRIC MOTOR
12 – HANDGRIP
13 – START-STOP SWITCH
14 – PROTECTION FUSE
15 – TORQUE SELECTOR
The impact wrench is supplied complete with the following accessories:
– 3 pcs. "CLIP-NR" retaining circlip for most common sockets with
grooved diameter between 47 and 57 mm (1.85 and 2.25 in.)
– 1 pc. "CLIP-NR57" retaining circlip for sockets with grooved
diameter between 57 and 67 mm (2.25 and 2.64 in.)
WARNING ON THE USE OF ELECTRICAL EXTENSION CABLES:
The Impact wrench is fitted with a 1,5m long supply cable. Any extension cable used must
be in proper working order and have an Earthing connection.
The extension cable must be fully extended and not exceed 15m (50ft) in length. In order
to safely provide the maximum output, the extension cable must have 3 conductors, each
at least:
- 3x1,5 mm (3x16 AWG) for the NR-13E
2
- 3x2,5 mm (3x13 AWG) for the NR-13E-110
2
5
2. DESCRIPTION (Ref. to Fig. 1)
ENGLISH